Reference Guide

Required Command Levels (1, 2, 3) Optional name=value pairs Use
NOTE: When the connectors are
connected to the enclosure in
redundant path mode, the Name of the
connector is displayed as Logical
Connector.
Omreport Cachecade Status
The following table describes the syntax for the omreport Cachecade commands
Table 79. Omreport Cachecade Commands
Required Command Levels (1, 2,
3)
Optional name=value pairs Use
omreport storage cachecade Displays property information for all
cachecades on all controllers.
controller=id, where id is the controller
number. For example, controller=0.
Displays all cachecades on the specified
controller.
controller=id cachecade=id, where id is
the controller number and the cachecade
number. For example, controller=0
cachecade=1.
Displays the specified cachecade on the
controller.
Omreport Storage Tape
The following table describes the syntax for the omreport storage tape command.
Table 80. Omreport Storage Tape Commands
Required Command Levels (1, 2,
3)
Optional name=value pairs Use
omreport storage tape Display tape drive properties.
controller=id, where id is the controller
number. For example: controller=0.
Displays all tape drives.
connector=id Displays all the tape drives on the
specified connector.
tape=<tape id>, where
tapeid=id=<connector:targetID>
Displays the specified tape drive.
136