Reference Guide

Omreport Controller Status
The following table describes the syntax for the omreport Controller commands
Table 69. Omreport Controller Commands
Required Command
Levels (1, 2, 3)
Optional name=value pairs Use
omreport storage
controller
Displays property information for all controllers attached to
the system.
controller=id, where id is the
controller number. For example,
controller=0
Displays the specified controller and all attached
components such as enclosures, virtual disks, physical
disks, and so on.
controller=id info=foreignkeyids Displays the locked foreign configuration information for
import or clear operations.
controller=id info=pdslotreport
Displays the empty and occupied slot details of enclosures
in the controller.
NOTE: This command is not supported on Blackplane,
SCSI, and SWRAID controllers.
Omreport Enclosure Status
The following sections provide the omreport storage enclosure command syntax required to execute the enclosure
commands. The following table describes the syntax for the omreport Enclosure commands.
Table 70. Omreport Enclosure Commands
Required Command
Levels (1, 2, 3)
Optional name=value pairs Use
omreport storage
enclosure
Displays property information for all
enclosures attached to the system.
controller=id, where id is the controller
number
Displays all enclosures connected to the
controller.
controller=id enclosure=<ENCLOSUREID>,
where id is the controller number and
<ENCLOSUREID>is the enclosure ID.
Example for SCSI controllers: controller=0
enclosure=2. Example for SAS controllers:
controller=0 enclosure=1:2.
Displays the specified enclosure and its
components.
Omreport Temperature Probe Status
The following table describes the syntax for the omreport Probe commands
131