Reference Guide

Table 67. Omreport Physical Disk Commands
Required Command Levels (1, 2, 3)
And name=value pair
Optional name=value pairs Use
omreport storage pdisk controller=id, where id is the
controller number. For example,
controller=0
Displays all physical disks attached to
the specified controller.
NOTE: If a physical disk was
replaced by another disk as part
of the replace member operation,
the state of the physical disk is
displayed as Replacing.
vdisk=id, where id is the virtual disk
number. For example, vdisk=1
Displays all physical disks included in
the specified virtual disk on the
controller.
cachecade=id where id is the
cachecade number. For example,
cachecade=1
Displays all physical disks included in
the specified cachecade on the
controller.
connector=id where id is the
connector number. For example,
connector=1
Displays all physical disks attached to
the specified connector on the
controller.
pdisk=connectorID : targetID |
connectorID : enclosureID : slotID,
where connectorID:targetID is the
connector number and the physical
disk number and
connectorID:enclosureID:slotID is the
connector number, enclosure number,
and slot number. For example,
pdisk=0:2 or pdisk=0:1:2
Displays the specified physical disk
on the specified connector on the
controller.
omreport Virtual Disk Status
The following table describes the syntax for the omreport Virtual Disk commands:
Table 68. omreport Virtual Disk Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage vdisk Displays property information for all
virtual disks on all controllers.
controller=id, where id is the
controller number. For example,
controller=0.
Displays all virtual disks on the
specified controller.
controller=id vdisk=id, where id is the
controller number and the virtual disk
number. For example, controller=0
vdisk=1.
Displays the specified virtual disk on
the controller.
130