Installation manual

Installing Dependent RPMs
To install the dependent RPMs not available on the operating system media:
1. Make sure that Pegasus RPMs are uninstalled.
2. Check if the openwsmand and sfcbd binaries are already installed using make-install. Check by running the
commands: openwsman or sfcbd or you can check the existence of the binaries in the /usr/local/sbin directory.
3. If the binaries are installed, uninstall these binaries.
4. Check for the required dependencies for the openwsman and sfcbd RPMs listed in the following table.
Table 5. Required Dependencies
Packages Red Hat Enterprise Server SUSE Linux Enterprise Server
Openwsman
OpenSSL
LibXML
Pkgconfig
CURL
Chkconfig
Initscript
SBLIM-SFCC
LibOpenSSL
LibXML
Pkg-config
libCURL
aaa_base
aaa_base
SBLIM-SFCC
SBLIM SFCC CURL LibCURL
SBLIM SFCB
zlib
CURL
PAM
OpenSSL
Chkconfig
Initscript
zlib
LibCURL
PAM
LibOpenSSL
aaa_base
aaa_base
5.
Install the dependent RPMs. You can install the RPMs:
– with a single command rpm -ivh rpm1 rpm2 rpm3 rpm4 … rpmN
or
– individually
NOTE: If you are installing RPMs individually, follow this sequence.
rpm -ivh sblim-sfcb-x.x.x.rpm
rpm -ivh sblim-sfcc-x.x.x.rpm
NOTE: Install the libwsman and openwsman client RPMs simultaneously as they have cyclic dependency.
rpm -ivh libwsman1-x.x.x.rpm openwsman-client-x.x.x.rpm
rpm -ivh openwsman-server-x.x.x.rpm
Post-Installation Configuration for Remote Enablement
This section details the steps to configure the dependent RPMs if you have installed the Remote Enablement feature.
The post-installation configuration script is available at /opt/dell/srvadmin/etc/ on the server file system.
After installing all the dependent RPMs and the Remote Enablement feature, execute the autoconf_cim_component.sh
script.
Before executing the autoconf_cim_component.sh script, make sure that Dell OpenManage is installed.
25