Reference Guide

Introduction 21
Message:
Error! Number with up to 3 digits after decimal
point expected, read 3.3000
The value given by the command specifies more than
3 digits after the decimal point. A valid minimum
warning threshold value for volts contains up to
3 digits after the decimal point.
Revised command:
omconfig chassis volts index=3 minwarnthresh=3.300
When you type the revised command with three decimal points, you receive
another error message:
Error! This voltage probe min warning threshold
must be between 11.400 and 12.480.
Revised command:
omconfig chassis volts index=3 minwarnthresh=
11.500
Message:
Voltage probe warning threshold(s) set
successfully.
Scripting and Comparing Using CLI
The Server Administrator CLI allows administrators to write batch programs
for the operating system. For an enterprise with many systems, an
administrator could write a configuration script that specified the warning
thresholds for each major component of a system and also specified a set of
actions that the administrator wants each system to take in case of a warning
or failure event. In the most critical cases, the administrator could write a
script so that the system shuts down to prevent damage. The administrator
could then distribute and execute the script to many managed systems at the
same time. Such a scenario facilitates configuring any number of new systems
acquired by a company and makes implementation of new system
administration policies easier across many existing systems that require
reconfiguration.