User's Manual

Virtual Disks 253
NOTE: The PERC 4/SC, 4/DC, 4e/DC, 4/Di, 4e/Si, and 4e/Di controllers do not allow
you to change or reconfigure the virtual disk size.
NOTE: The PERC S100 and S300 controllers do not allow you to change the RAID
level.
3 Click Continue to go to the next screen or Exit Wizard if you want to
cancel.
To Reconfigure a Virtual Disk (Expand Virtual Disk Capacity): Step 2 of 3
1 Enter the percentage of the free disk size available by which you want to
expand the virtual disk capacity. The screen displays the maximum free
size available and the description of the selected RAID level.
2 Click Continue to go to the next screen or click Exit Wizard if you want
to cancel.
Virtual Disk Task: Reconfigure (Step 3 of 3)
Does my controller support this feature? See Supported Features.
This screen enables you to review your changes before completing the virtual
disk reconfiguration.
To Reconfigure a Virtual Disk: Step 3 of 3
1 Review your changes. The New Virtual Disk Configuration table displays
the changes you have made to the virtual disk. The
Previous Virtual Disk
Configuration
displays the original virtual disk prior to reconfiguration.
2 Click Finish to complete the virtual disk reconfiguration. To exit without
changing the original virtual disk, click
Exit Wizard .
NOTE: On some controllers, performing a Rescan while a reconfiguration is in
progress causes the virtual disk configuration and the physical disk state to display
incorrectly. For example, changes to the virtual disk’s RAID level may not be
displayed and the state of physical disks that were added to the virtual disk may
display as Ready instead of Online.