User's Manual

176 Connectors
Table 9-2. Connector Properties
Property Definition
These icons represent the severity or health of the storage
component. For more information, see Storage Component
Severity. A Warning or Critical severity may indicate that
the connector is unable to communicate with attached
devices such as an enclosure. Check the status of attached
devices. For more information, see Cables Attached
Correctly and Isolate Hardware Problems.
Name This property displays the connector number.
State This property displays the current status of the connector.
Possible values are:
Ready—The connector is functioning normally.
Degraded—The connector has encountered a failure and is
operating in a degraded state.
Failed—The connector has encountered a failure and is no
longer functioning.
Connector Type This property displays whether the connector is operating
in RAID or SCSI mode. Depending on the controller type,
the connector can be either a SCSI connector or a SAS
port.
Termination This property indicates the termination type of the
connector.
Narrow—Indicates an 8 bit data bus.
Wide—Indicates a 16 bit data bus.
Unknown—Indicates that the termination type is
unknown.
Not Terminated—On a SCSI controller, this property
indicates that the data bus is not terminated. This property
is also displayed when the termination type is unknown.
SCSI Rate This property displays the SCSI speed for a SCSI device.