User's Manual

Controllers 107
Reset Configuration
Does my controller support this feature? See Supported Features.
Use the Reset Configuration task to erase all information on the controller so
that you can perform a fresh configuration. This operation destroys all data
and virtual disks on the controller and unassigns any hot spares.
You must completely reconfigure your storage after performing this operation.
CAUTION: Resetting a configuration permanently destroys all data on all virtual
disks attached to the controller. If the system or boot partition resides on these
virtual disks, it is destroyed.
NOTE: Resetting the controller configuration does not remove a foreign
configuration. To remove a foreign configuration, use the Clear Foreign
Configuration task.
To reset the controller configuration:
1 Review the virtual disks that is destroyed by resetting the controller
configuration. Make backups as necessary. Click
Blink at the bottom of
the screen to blink the physical disks included in the virtual disks.
2 Click Reset Configuration when you are ready to erase all information on
the controller. To exit without resetting the controller configuration, click
Go Back to Previous Page .