User's Manual

104 Controllers
Enable Alarm (Controller)
Does my controller support this feature? See Supported Features.
Use the Enable Alarm task to enable the controller’s alarm. When enabled,
the alarm sounds in the event of a device failure.
Disable Alarm (Controller)
Does my controller support this feature? See Supported Features.
Use the Disable Alarm task to disable the controller’s alarm. When disabled,
the alarm does not sound in the event of a device failure.
Quiet Alarm (Controller)
Does my controller support this feature? See Supported Features.
Use the Quiet Alarm task to quiet the controller’s alarm when it is sounding.
After it is quieted, the alarm is still enabled in the event of a future device
failure.
Test Alarm (Controller)
Does my controller support this feature? See Supported Features.
Use the Test Alarm task to test whether the controller alarm is functional.
The alarm sounds for about 2 seconds.
NOTE: The Test Alarm task is only available on the CERC SATA1.5/6ch controller.
Set Rebuild Rate
Does my controller support this feature? See Supported Features.
Use the Set Rebuild Rate task to change the rebuild rate. See Set Rebuild
Rate for more information.
Export Log File
Does my controller support this feature? See Supported Features.
Use this task to export the controller log to a text file. See Export Log for
more information.