Command Line Interface Guide

omreport: Viewing System Status Using the Instrumentation Service 49
Server Administrator displays a summary of the system’s firmware properties.
NOTE: To maintain consistency across the commands, the output format of this
command has changed. Change the user scripts as applicable.
NOTE: If iDRAC is installed, Server Administrator displays Life Cycle Controller
(LCC) version. If BMC is installed, Server Administrator displays Unified Server
Configurator (USC) version.
omreport chassis frontpanel or omreport mainsystem frontpanel
Use the omreport chassis frontpanel or omreport mainsystem frontpanel
command to view if the front panel button control settings, such as the Power
button and/or Nonmasking Interrupt (NMI) button (if present on the
system), are enabled or disabled.
If the Power button override is present on the system, check whether the
Power button override is enabled or not. If enabled, the Power button turns the
power to the system On and Off.
If the NMI button is present on the system, check whether the NMI button
is enabled or not. Use the NMI button to troubleshoot software and device
errors when using certain operating systems.
The Front Panel LCD Security Access displays if the front panel encryption
access information is set to View, Modify, or Disable.
The Front Panel LCD Information displays information such as service tag,
remote indication status, and so on.
omreport chassis fru or omreport mainsystem fru
Use the omreport chassis fru or omreport mainsystem fru command to view
FRU information. When you type:
omreport chassis fru
or
omreport mainsystem fru
Server Administrator displays a summary of the system’s FRU information.
This information is available in the Server Administrator GUI, SNMP,
and Common Information Model and is primarily used to support
troubleshooting activities.