Command Line Interface Guide

omreport: Viewing System Status Using the Instrumentation Service 45
Table 3-4 displays the available groups of the BIOS setup parameters on
PowerEdge yx2x systems.
NOTE: Based on the hardware configuration, the attributes may vary in a specific
group.
RAID Channel A Displays whether RAID-on-motherboard Channel A is
detected as a RAID device or a SCSI device.
RAID Channel B Displays whether RAID-on-motherboard Channel B is
detected as a RAID device or a SCSI device.
SATA
Serial Port 1 Displays whether serial port 1 is mapped to a COM port, a
COM port 1, a COM port 3, a COM1 BMC, a BMC Serial,
a BMC NIC, a BMC RAC, or is disabled.
Serial Port 2 Displays whether serial port 2 is mapped to a COM port, a
COM port 2, a COM port 4, or is disabled.
Speaker Displays whether the speaker is on or off.
USB or USBB Displays whether the USB port is enabled or disabled.
Secondary SCSI Displays whether the device is enabled or disabled.
Serial Communications Displays whether COM port 1 and COM port 2 are off or on
with or without console redirection.
Console Redirection
After Boot
Displays whether console redirection after system reboot is
enabled or disabled.
External Serial
Connector
Displays whether the external serial connector is mapped to
Serial Device 1, Serial Device 2, or a Remote Access Device.
Console Redirection
Failsafe Baud Rate
Displays the setting for console redirection failsafe baud
rate.
Serial Address Select Displays port address for the serial devices.
Table 3-3. BIOS Setup Parameters on Systems prior to Dell PowerEdge
yx2x systems
Parameters Description