Command Line Interface Guide

omreport: Viewing System Status Using the Instrumentation Service 43
User accessible USB
Ports
Displays whether the user-accessible USB port is enabled or
disabled.
CPU Virtualization
Tec hnology
Displays the additional hardware capabilities provided by
Virtualization Technology.
AC Power Recovery
Mode
Displays the system state when input power is restored after
an outage.
Embedded SATA
Controller
Displays whether the embedded SATA controller is set to
ATA mode, RAID mode, or is disabled.
SATA port 0 Displays the state of SATA port 0.
SATA Port 1 Displays the state of SATA port 1.
Dual NIC (1/2) Displays whether NIC 1 and NIC 2 with PXE/iSCSI is
enabled or disabled.
Dual NIC (3/4) Displays whether NIC 3and NIC 4 with PXE/iSCSI is
enabled or disabled.
NIC 1 Displays whether the first NIC is enabled (with or without
PXE/iSCSI) or disabled during system boot.
NIC 2 Displays whether the second NIC is enabled (with or
without PXE/iSCSI) or disabled during system boot.
NIC 3 Displays whether the third NIC is enabled (with or without
PXE/iSCSI) or disabled during system boot.
NIC 4 Displays whether the fourth NIC is enabled (with or
without PXE/iSCSI) or disabled during system boot.
Trusted Cryptographic
Module (TCM)
Displays if TCM is on or off.
Trust ed Pla tform
Module (TPM)
Security
Displays if TPM is off, on with pre-boot measurements, or
on without pre-boot measurements.
Internal USB Port
(number)
Displays if the internal USB is enabled or disabled.
NOTE: Server Administrator may not display the USB
sequence number if there is only one USB port on the system.
Operating System
Watchd o g Ti m er
Displays whether the operating system watchdog timer is
enabled or disabled.
Table 3-3. BIOS Setup Parameters on Systems prior to Dell PowerEdge
yx2x systems
Parameters Description