Command Line Interface Guide

42 omreport: Viewing System Status Using the Instrumentation Service
omreport chassis biossetup or omreport mainsystem biossetup
Use the omreport chassis biossetup or omreport mainsystem biossetup
command to view BIOS setup parameters that are normally available only
during system boot. Type:
omreport chassis biossetup
or
omreport mainsystem biossetup
NOTE: To maintain consistency across the commands, the output format of this
command has changed. Change the user scripts as applicable.
To view the BIOS Setup parameters in short form, type:
omreport chassis biossetup display=shortnames
Table 3-3 dis plays the ava i lable BIOS setup parameters on systems prior to
PowerEdge yx2x systems.
NOTE: All the BIOS Setup parameters are not displayed. Only those BIOS setup
properties configured during system boot are displayed.
Table 3-3. BIOS Setup Parameters on Systems prior to Dell PowerEdge yx2x systems
Parameters Description
Attribute
Bootsequence Displays the device used to boot the system.
Numlock Displays whether the keypad is used as number keys.
Embedded Video
Controller
Displays whether the Embedded Video Controller option is
enabled or disabled.
Boot Mode Displays whether the boot mode is configured to BIOS or
Unified Extensible Firmware Interface (UEFI.)
Processor C1-E Displays the Processor C1-E status.
CPU Execute Disable Displays whether the Execute Disable (XD) option is
enabled or disabled.
Processor C State
Control
Displays whether the Processor C State Control option is
enabled or disabled.
Processor CMP Displays the number of cores enabled per processor.