Command Line Interface Guide

242 omconfig storage Commands
where id is the controller ID as reported by the omreport storage controller
command.
Example Syntax
To rescan controller 1, type:
omconfig storage controller action=rescan
controller=1
NOTE: The rescan controller is not supported on non–RAID SCSI and SAS
controllers. Reboot the system to make the configuration changes visible on non-
RAID SCSI controllers.
omconfig Enable Controller Alarm
Use the following omconfig command syntax to enable the controller alarm.
See the Dell OpenManage Online Help for more information about Enable
Controller Alarm.
Complete Syntax
omconfig storage controller action=enablealarm
controller=id
where id is the controller ID as reported by the omreport storage controller
command.
Example Syntax
To enable the alarm on controller 1, type:
omconfig storage controller action=enablealarm
controller=1
omconfig Disable Controller Alarm
Use the following omconfig command syntax to disable the controller alarm.
See the Dell OpenManage Online Help for more information about Disable
Controller Alarm.
Complete Syntax
omconfig storage controller action=disablealarm
controller=id