Command Line Interface Guide

omconfig storage Commands 241
omconfig Rescan Controller
Use the following omconfig command syntax to rescan a controller.
See Dell OpenManage Online Help for more information about Rescan
Controller.
Complete Syntax
omconfig storage controller action=rescan
controller=id
action=setpdiskpwrmanagement controller=id
spindownunconfigureddrives=<enabled/disabled>
spindownhotspares=<enabled/disabled>
spindownconfigureddrives=<enabled/disabled>
idlec=<enabled/disabled> spindowntimeinterval=<30 to
1440>(minutes) spinupstarttime=<HH:MM:AM/PM>
spinuptimeinterval=<1 to 24>(hours)
NOTE: Specify spinupstarttime and spinuptimeinterval only when
you set spindownconfigureddrives=enabled.
action=setpatrolreadmode controller=id
mode=<manual | auto | disable>
action=startpatrolread controller=id
action=stoppatrolread controller=id
action=createcachecade controller=id pdisk=<PDISKID>
[name=<string>]
action=enablelkm controller=id keyid=<keyid> passphrase=
<passphrase string> [escrow=yes] [filepath=<Absolute path to
the escrow file>]
NOTE: If you set escrow=yes, specify the escrow file path.
action=switchtolkm controller=id keyid=<keyid> passphrase=
<passphrase string> [escrow=yes] [filepath=<Absolute path to
the escrow file>]
NOTE: If you set escrow=yes, specify the escrow file path.
action=rekeylkm controller=id
action=convertraidtononraid controller=id pdisk=<PDISKID>
action=convertnonraidtoraid controller=id pdisk=<PDISKID>
Table 8-4. omconfig Controller Commands
(continued)
Required Command
Levels (1, 2, 3)
Optional name=value pairs