Command Line Interface Guide

omconfig storage Commands 223
Example Syntax
In this example, to export log on physical disk 3 on connector 0 of controller
1. On a SAS controller, the physical disk resides in enclosure 2.
Example for SAS Controllers
To export log of the physical disk described in this example, type:
omconfig storage pdisk action=exportreliabilitylog
controller=1 pdisk=0:2:3
omconfig Convert RAID to Non-RAID
Use the following omconfig command to convert RAID to non-RAID on a
physical disk.
Complete Syntax
omconfig storage pdisk action=convertraidtononraid
controller=id pdisk=<PDISKID>
where id is the controller ID. The <PDISK> variable specifies the physical
disk.
To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.
NOTE: To convert multiple RAID to non-RAID on a given controller, use omconfig
storage controller action=convertraidtononraid command. For more information,
see "omconfig Convert Multiple RAID to Non-RAID" on page 263.
Example Syntax
In this example, to convert RAID to non-RAID on physical disk 3 on
connector 0 of controller 1. On a SAS controller, the physical disk resides in
enclosure 2.
Example for SAS Controllers
To convert RAID to non-RAID on the physical disk described in this example,
type:
omconfig storage pdisk action=raidtononraid
controller=1 pdisk=0:2:3