Command Line Interface Guide

218 omconfig storage Commands
To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.
Example Syntax
In this example, you want to rebuild physical disk 3 on connector 0 of
controller 1. On a SAS controller, the physical disk resides in enclosure 2.
Example for SCSI, SATA, and ATA Controllers
To rebuild the physical disk described in this example, type:
omconfig storage pdisk action=rebuild controller=1
pdisk=0:3
Example for SAS Controllers
To rebuild the physical disk described in this example, type:
omconfig storage pdisk action=rebuild controller=1
pdisk=0:2:3
omconfig Cancel Rebuild Physical Disk
Use the following omconfig command syntax to cancel a rebuild that is in
progress. If you cancel a rebuild, the virtual disk remains in a degraded state.
See the Dell OpenManage Online Help for more information about Cancel
Rebuild Physical Disk.
Complete Syntax
omconfig storage pdisk action=cancelrebuild
controller=id pdisk=<PDISKID>
where id is the controller ID. The <PDISK> variable specifies the
physical disk.
To obtain these values, type omreport storage controller to display the
controller IDs and then type omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.