Command Line Interface Guide

omreport storage Commands 201
The following sections provide the omreport storage enclosure command
syntax required to execute the enclosure commands.
omreport Temperature Probe Status
Table 7-6 describes the syntax for the omreport Probe Commands.
Table 7-6. omreport Temperature Probe Commands
Required Command Levels
(1, 2, 3) and name=value pair
Optional name=value pairs Use
omreport storage
enclosure
Displays property
information for all enclosures
attached to the system.
controller=id enclosure=
<ENCLOSUREID>
info=temps
where id is the controller
number and
<ENCLOSUREID>
is
the enclosure ID. Example
for SCSI controllers:
controller=0 enclosure=2
info=temps. Example for
SAS controllers:
controller=0 enclosure=
1:2 info=temps.
Displays the temperature
probes for the specified
enclosure.
controller=id enclosure=
<ENCLOSUREID>
info=temps index=n
where id is the controller
number and
<ENCLOSUREID> is
the enclosure number and
“n” is the number of a
temperature probe. For
example: controller=0
enclosure=2 info=temps
index=1
Displays the temperature
probes for the specified
enclosure.