Command Line Interface Guide

196 omreport storage Commands
omreport Physical Disk Status
Table 7-2 describes the syntax for the omreport Physical Disk Commands.
battery Displays a list of the omreport storage battery
parameters for displaying battery information.
globalinfo Displays a list of the omreport storage
globalinfo parameters for displaying global
storage property information.
connector Displays a list of the omreport storage
connector parameters for displaying
connector information.
cachecade Displays a list of the omreport storage
cachecade parameters for displaying
cachecade properties.
Table 7-2. omreport Physical Disk Commands
Required Command
Levels (1, 2, 3) and name=
value pair
Optional name=value pairs Use
omreport storage
pdisk
controller=id
where id is the controller number.
For example: controller=0
Displays all physical disks
attached to the specified
controller.
NOTE: If a physical disk
was replaced by another
disk as part of the replace
member operation, the
state of the physical disk is
displayed as
Replacing.
vdisk=id
where id is the virtual disk number.
For example:
vdisk=1
Displays all physical disks
included in the specified
virtual disk on the
controller.
Table 7-1. omreport storage help
(continued)
Command
Level 1
Command
Level 2
Command
Level 3
Use