Command Line Interface Guide

omconfig system or servermodule assetinfo: Editing Cost of Ownership Values 187
Example Command for Adding System Information
To provide a value for a system parameter, type a command of the form:
omconfig system assetinfo info=system <name=value pair 2> or
omconfig servermodule assetinfo info=system <name=value pair 2>.
For example, type:
omconfig system assetinfo info=system location=
firstfloor
or
omconfig servermodule assetinfo info=system
location=firstfloor
The following message is displayed:
Asset information set successfully.
You can type more than one omconfig system assetinfo or omconfig
servermodule assetinfo command at the same time, as long as all the
parameters for name=value pair 2 belong to the same name=value pair 1. For
an example, see "Example Commands for Adding Acquisition Information"
on page 173.
Adding Warranty Information
Use the omconfig system warranty or omconfig servermodule warranty
command to assign values for warranty information. A warranty is a contract
between the manufacturer or dealer and the purchaser of a system.
The warranty identifies the components that are covered for repair or
replacement for a specified length of time or usage. For details on editing
extended warranty values, see "Adding Extended Warranty Information" on
page 175. Table 5-12 shows the valid parameters for adding warranty
information.