Command Line Interface Guide

omconfig system or servermodule assetinfo: Editing Cost of Ownership Values 181
Example Command for Adding Outsource Information
To provide a value for an outsource parameter, type a command of the form:
omconfig system assetinfo info=outsource <name=value pair 2> or
omconfig servermodule assetinfo info=outsource <name=value pair 2>.
For example, type:
omconfig system assetinfo info=outsource
providerfee=75
or
omconfig servermodule assetinfo info=outsource
providerfee=75
The following message is displayed:
Asset information set successfully.
You can type more than one omconfig system assetinfo or omconfig
servermodule assetinfo command at the same time, as long as all the
parameters for name=value pair 2 belong to the same name=value pair 1. For
an example, see "Example Commands for Adding Acquisition Information"
on page 173.
Adding Owner Information
The owner is the party that holds legal property title to the system. Table 5-8
shows the valid parameters for adding owner information.