Command Line Interface Guide

166 omconfig: Managing Components Using the Instrumentation Service
omconfig system webserver or omconfig servermodule webserver
Use the omconfig system webserver or omconfig servermodule webserver
command to start or stop the Web server. Table 4-29 shows the valid
parameters for the command.
omconfig system recovery or omconfig servermodule recovery
Use the omconfig system recovery or omconfig servermodule recovery
command to set the action when the operating system hangs or crashes. You
can also set the number of seconds that must pass before the system is
considered to have a hung operating system. Table 4-30 shows the valid
parameters for the command.
NOTE: Upper and lower limits for the timer are dependent on the system model and
configuration.
Table 4-29. Web Server Configuration Parameters
name=value pair Description
action=start Starts the Web server.
action=stop Stops the Web server.
action=restart Restarts the Web server.
Table 4-30. Recovery Parameters
name=value pair Description
action=none Takes no action when the operating system is hung or has
crashed.
action=reboot Shuts down the operating system and initiates system startup,
performing BIOS checks, and reloading the operating system.
action=poweroff Turns off electrical power to the system.
action=powercycle Turns off electrical power to the system, pauses, turns the power
on, and reboots the system. Power cycling is useful when you
want to re-initialize system components such as hard drives.
timer=<n> Number of seconds that must pass before the operating system
in a system is considered hung operating system (from 20
seconds to 480 seconds.)