Command Line Interface Guide

omconfig: Managing Components Using the Instrumentation Service 163

omconfig system events or omconfig servermodule events

Use the omconfig system events or omconfig servermodule events command

to enable and disable SNMP traps for the components on your system.

NOTE: Not all event types are present on the system.

There are four parameters in the name=value pair component of the

omconfig system events command:

•Source

•Type

•Severity

•Index

Source

At present, source=snmptraps is a required name=value pair because

SNMP is currently the only supported source of event notification for the

system’s components.

omconfig system events source=snmptraps

omconfig servermodule events source=snmptraps

Typ e

Type refers to the name of the component(s) involved in the event.

Table 4-27 shows the valid parameters for system event types.

event=intdualsdcardwarn Sets actions that Server Administrator performs when

an internal dual SD card warning is displayed.

event=intdualsdcardabsent Sets actions that Server Administrator performs when

an internal dual SD card is not available.

event=

intdualsdcardredunlost

Sets actions that Server Administrator performs when

the redundancy of an internal dual SD card is lost.

event=watchdogasr Enables or disables alert generation configured by the

ASR when the system has hung or is not responding.

Table 4-26. omconfig system platformevents

(continued)

Event Name Description