Command Line Interface Guide

omconfig: Managing Components Using the Instrumentation Service 159

omconfig system pedestinations or omconfig servermodule

pedestinations

Use the omconfig system pedestinations or omconfig servermodule

pedestinations command to set IP addresses for alert destinations.

Table 4-24 shows the valid parameters for the command.

NOTE: You can either specify the index and IP address as parameters together or

you can set the only community string as a parameter.

NOTE: Index 1 to 4 accepts an IPv4 address and index 5 to 8 accepts an IPv6

address.

omconfig system platformevents or omconfig servermodule

platformevents

Use the omconfig system platformevents or omconfig servermodule

platformevents command to configure shutdown action, if any, taken for a

specific platform event. You can also enable or disable platform event filter

alert generation.

CAUTION: If you set a platform event shutdown action to anything other than

none

power reduction

, the system is forcefully shutdown when the specified

event occurs. This shutdown is initiated by firmware and is carried out without

first shutting down the operating system or any of the applications running on

your system.

Table 4-24. omconfig system pedestinations or omconfig servermodule pedestinations

name=Value Pair Description

destenable=true |

false

true: Enables an individual platform event filter destination

after a valid IP address has been set.

false: Disables an individual platform event filter.

index=number Sets the index for the destination.

ipaddress=ipv4|ipv6

address

Sets the IP address for the destination.

communitystr=text Sets the text string that acts as a password and is used to

authenticate SNMP messages sent between the BMC and the

destination management station.