User's Manual

Quiet Alarm (Controller)

Does my controller support this feature? See Supported Features.
Use the Quiet Alarm task to quiet the controller's alarm when it is sounding. After it is quieted, the alarm is still enabled in the event of a future device failure.

Test Alarm (Controller)

Does my controller support this feature? See Supported Features.
Use the Test Alarm task to test whether the controller alarm is functional. The alarm sounds for about 2 seconds.

Set Rebuild Rate

Does my controller support this feature? See Supported Features.
Use the Set Rebuild Rate task to change the rebuild rate. See Set Rebuild Rate for more information.

Export Log File

Does my controller support this feature? See Supported Features.
Use this task to export the controller log to a text file. See Export Log for more information.

Controller Components
For information on attached components, see the following topics:
l Battery Properties and Tasks
l Connector Properties and Tasks
l Enclosure and Backplane Properties and Tasks
l Firmware/Driver Properties
l Virtual Disk Properties and Tasks

Foreign Configuration Operations

Does my controller support this feature? See Supported Features.
The Foreign Configuration Operations task provides a preview of the foreign configurations that you can import. This task is available on PERC 6 controllers
with firmware version 6.1 and later. For more information, see Foreign Configuration Operations.

Manage Physical Disk Power

Does my controller support this feature? See Supported Features.
The Manage Physical Disk Power task allows to manage the power consumed by the physical disks by spinning down the hotspares and unconfigured drives
if there are unattended for a specified amount of time. This option is provided only with PERC H700 and PERC H800 controllers with the firmware version 7.1
and above.
Set Rebuild Rate
NOTE: The Test Alarm task is only available on the CERC SATA1.5/6ch controller.