User's Manual

To enable Revertible Hot Spare:
1. On the Change Controller Properties page, enable Revertible Hot Spare and Auto replace on predictive failure.
2. Click Apply Changes.
To locate this task in Storage Management:
1. Expand the Storage tree object to display the controller objects.
2. Select a controller object on which you want to enable the revertible hot spare task and select the Information/Configuration tab.
3. From the Controller Task drop down menu, select Change Controller Properties and click Execute.
Instant Encrypt Erase
Does my controller support this feature? See Supported Features.
Use the Instant Encrypt Erase task to erase an encrypted physical disk. This task is available for:
l Unconfigured SED drive
l Foreign configured encrypted drives
l Unconfigured and foreign SED drive even when an Encryption Key is not present in the controller
To locate this task in Storage Management:
1. Expand the Storage tree object to display the controller objects.
2. Expand a controller object.
3. Expand a Connector object.
4. Expand the enclosure or Backplane object.
5. Select the Physical Disks object.
6. Select Instant Encrypt Erase from the Available Tasks drop-down menu of the physical disk you want to clear.
7. Click Execute.
Back to Contents Page
NOTE: To use the Revertible Hot Spare task, you should have assigned a hot spare to the virtual disk.
NOTE: If the disk is not SMART-enabled or if the Auto Replace on Predictive Failure option is disabled, the failed disk is not replaced automatically.
NOTE: The Rebuild rate for Revertible Hot Spare is the same as defined for the controller.
CAUTION: Instant Encrypt Erase permanently erases all data present on the disk.