Messages Reference Guide

16 Introduction
Memory device
location:
<Device name in
chassis>
Specifies the location of the memory module in the
chassis, for example:
Memory device location: DIMM_A
Number of devices
required for full
redundancy:
<Number>
Specifies the number of power supply or cooling devices
required to achieve full redundancy, for example:
Number of devices required for full
redundancy: 4
Peak value (in
Watts): <Reading>
Specifies the peak value in Watts, for example:
Peak value (in Watts): 1.693
Possible memory
module event cause:
<list of causes>
Specifies a list of possible causes for the memory module
event, for example:
Possible memory module event cause:
Single bit warning error rate exceeded
Single bit error logging disabled
Power Supply type:
<type of power
supply>
Specifies the type of power supply, for example:
Power Supply type: VRM
Previous redundancy
state was: <State>
Specifies the status of the previous redundancy message,
for example:
Previous redundancy state was: Lost
Previous state was:
<State>
Specifies the previous state of the sensor, for example:
Previous state was: OK (Normal)
Processor sensor
status: <status>
Specifies the status of the processor sensor, for example:
Processor sensor status: Configuration
error
Redundancy unit:
<Redundancy
location in
chassis>
Specifies the location of the redundant power supply or
cooling unit in the chassis, for example:
Redundancy unit: Fan Enclosure
SD card device
type: <Type of SD
card device>
Specifies the type of SD card device, for example:
SD card device type: Hypervisor
Table 1-2. Event Description Reference
(continued)
Description Line Item Explanation