Command Line Interface Guide

94 omconfig: Managing Components
attribute=
bootorder
sequence=aliasname1,
aliasname2,.....
aliasnameN
Configures the boot sequence according
to the set aliasnames. To view the set
alias names, run the command
omreport chassis
biossetup attribute=
bootorder
.
NOTE: On Linux systems, user/user
groups upgraded to
administrator/administrator groups
cannot configure this BIOS setup setting.
attribute=
hddorder
sequence=aliasname1,
aliasname2,.....
aliasnameN
Configures the BIOS setup hard disk
sequence according to the set
aliasnames. Changes takes effect after
rebooting the system. To view the set
alias names, run the command
omreport chassis
biossetup attribute=
bootorder
.
NOTE: On Linux systems, user/user
groups upgraded to
administrator/administrator groups
cannot configure this BIOS setup setting.
attribute=cstates setting=enabled |
disabled
enabled: Enables the processor to go into a
deep sleep state when the system is not
utilized.
disabled: Disables the processor to go
into a deep sleep state when the system
is not utilized.
Table 4-3. BIOS Setup Settings
(continued)
name=value pair 1
attribute=
name=value pair 2
setting=
Description