Command Line Interface Guide
88 omconfig: Managing Components
leds P, A Specifies when to flash a
chassis fault LED or chassis
identification LED, and
allows you to clear the LED
for the system's hard drive.
memorymode A Enables or disables the
spare bank, mirroring, raid,
and DDDC (Double Device
Data Correction) memory
modes, and also specify
which mode to use.
pwrmanagement P, A Allows you to choose
between maximum power
economy and optimized
performance of the system.
pwrmonitoring P, A Configures power
consumption information
and thresholds.
remoteaccess A Configures remote access
information.
temps P, A Sets warning threshold
values by default or value.
NOTE: You cannot change
threshold values on ESM3
and PowerEdge x8xx
systems.
volts P, A Sets warning threshold
values by default or value.
NOTE: You cannot change
threshold values on ESM3
and PowerEdge x8xx
systems.
Table 4-2. omconfig Command Level 1, Level 2, and Level 3
(continued)
Command
Level 1
Command Level
2
Command Level 3 User
Privilege
Required
Use