Command Line Interface Guide

44 omreport: Viewing System Status
IDE Primary Drive 0 Displays whether the device is automatically detected and
enabled or if the device is disabled.
IDE Primary Drive 1 Displays whether the device is automatically detected and
enabled or if the device is disabled.
Intrusion Displays whether the intrusion check is enabled or disabled
during system boot.
Mouse Displays whether the mouse is enabled or disabled.
Optical Drive
Controller
Displays whether the optical drive controller is enabled or
disabled.
Parallel port address Displays whether the address is located on LPT1, LPT2, and
LPT3, or if it is disabled.
Parallel port mode Displays the setting associated with the parallel port.
Primary SCSI Displays whether the device is on or off.
RAID on motherboard Displays whether RAID-on-motherboard is detected as a
RAID device, a SCSI device, or if the device is disabled
during system boot.
RAID Channel A Displays whether RAID-on-motherboard Channel A is
detected as a RAID device or a SCSI device.
RAID Channel B Displays whether RAID-on-motherboard Channel B is
detected as a RAID device or a SCSI device.
SATA
Serial Port 1 Displays whether serial port 1 is mapped to a COM port, a
COM port 1, a COM port 3, a COM1 BMC, a BMC Serial,
a BMC NIC, a BMC RAC, or is disabled.
Serial Port 2 Displays whether serial port 2 is mapped to a COM port, a
COM port 2, a COM port 4, or is disabled.
Speaker Displays whether the speaker is on or off.
USB or USBB Displays whether the USB port is enabled or disabled.
Secondary SCSI Displays whether the device is enabled or disabled.
Serial Communications Displays whether COM port 1 and COM port 2 are off or on
with or without console redirection.
Table 3-3. BIOS Setup Parameters (continued)
Parameters Description