Command Line Interface Guide

omreport: Viewing System Status 43
NIC 1 Displays whether the first NIC is enabled (with or without
PXE/iSCSI) or disabled during system boot.
NIC 2 Displays whether the second NIC is enabled (with or
without PXE/iSCSI) or disabled during system boot.
NIC 3 Displays whether the third NIC is enabled (with or without
PXE/iSCSI) or disabled during system boot.
NIC 4 Displays whether the fourth NIC is enabled (with or
without PXE/iSCSI) or disabled during system boot.
Trusted Cryptographic
Module (TCM)
Displays if TCM is on or off.
Trust ed Pla tform
Module (TPM)
Security
Displays if TPM is off, on with pre-boot measurements, or
on without pre-boot measurements.
Internal USB Port
(number)
Displays if the internal USB is enabled or disabled.
NOTE: Server Administrator may not display the USB
sequence number if there is only one USB port on the system.
Operating System
Watchd o g Ti m er
Displays whether the operating system watchdog timer is
enabled or disabled.
HT Assist Displays the status of the probe filter chipset option.
Internal SD Card Displays whether the internal SD card is enabled or
disabled.
Bezel Displays whether the bezel removal intrusion check during
system reboot is enabled or disabled.
Console Redirection Displays if the BIOS screen is redirected over a particular
serial port or if it is turned off.
Diskette Displays whether the diskette is disabled, auto enabled, or
read-only.
Demand Based Power
Management (DBS)
Displays whether DBS is enabled or disabled on the system.
Embedded Hypervisor Displays whether the embedded hypervisor is enabled or
disabled.
IDE Displays whether the drive is enabled or disabled.
Table 3-3. BIOS Setup Parameters
(continued)
Parameters Description