Command Line Interface Guide

226 omconfig storage Commands
size=<number | max | min> Parameter (Required)
Table 8-6 indicates how to specify the size=<number | max | min>
parameter.
PDISKID=<connector:enclosureID:targetID | connector:targetID>
Use this parameter to specify the physical disks to included in the virtual disk.
When reconfiguring a virtual disk, you must specify all physical disks to be
included in the reconfigured virtual disk. The physical disk specification
applies to physical disks in the original virtual disk and continues to be in the
reconfigured virtual disk and to any new physical disks being added to the
reconfigured virtual disk. Some controllers allow you to remove a physical disk
from a virtual disk. In this case, do not specify the physical disk to be
removed.
The pdisk=<PDISKID> parameter indicates a physical disk by specifying
either connector:enclosureID:targetID or connector:targetID.
stripesize=< 2kb| 4kb| 8kb| 16kb| 32kb| 64kb|
128kb>] Parameter (Optional)
Different controllers support different stripe sizes. See the Dell OpenManage
Online Help for more information on stripe sizes supported for a controller.
All stripe sizes are specified in kilobytes. For example, when specifying 128 KB
as the stripe size, type:
stripesize=128kb
Table 8-6. Size Parameter
size=<number | max | min>
Parameter Specification
Description
size=<n> Use this specification to indicate a specific size for the virtual
disk. The virtual disk size may be specified in b (bytes), m
(megabytes), or g (gigabytes). For example, size=500m
indicates that the virtual disk should be 500 MB.
size=max To create a virtual disk that is the maximum size possible,
specify size=max. When creating a RAID-50 virtual disk,
this parameter must be specified as size=max.
size=min To create a virtual disk that is the minimum size possible,
specify size=min.