Command Line Interface Guide

omconfig storage Commands 223

In some circumstances, you may receive a warning message if this command

deletes the system or boot partition. You can override this warning by using

the force=yes parameter. In this case, the syntax is as follows:

omconfig storage controller action=resetconfig

controller=id force=yes

Example Syntax

To reset the configuration on controller 1, type:

omconfig storage controller action=resetconfig

controller=1

omconfig Create Virtual Disk

The Dell OpenManage Online Help provides additional information about

creating virtual disks.

The omconfig syntax for creating a virtual disk has several parameters.

You must specify the following parameters:

•

Controller (controller=id)

• RAID level (raid=<c| r0| r1| r1c| r5|r6| r10| r50|r60>)

•

Size (size=<number | max | min>)

Physical disk is specified as either:

For SCSI, SATA, and ATA Controllers

disk=connector:enclosureID:targetID

where connector:enclosureID:targetID is the connector number, enclosure

number, and slot number.

For example pdisk=0:1:2

For SAS Controllers

pdisk=connector:targetID

where connectorID:targetID is the connector number and the slot number.

For example: pdisk=0:2