Command Line Interface Guide

196 omconfig storage Commands
Example for SCSI, SATA, and ATA Controllers
To erase the physical disk described in this example, type:
omconfig storage pdisk action=instantsecureerase
controller=1 pdisk=0:3
Example for SAS Controllers
To erase the physical disk described in this example, type:
omconfig storage pdisk action=remove controller=1
pdisk=0:2:3
omconfig Initialize Physical Disk
Use the following omconfig command syntax to initialize a physical disk.
Complete Syntax
omconfig storage pdisk action=initialize
controller=id pdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport
command. To obtain these values, type omreport storage controller to display
the controller IDs and then type omreport storage vdisk controller=ID to
display the IDs for the virtual disks attached to the controller.
Example Syntax
To initialize physical disk 4 on controller 1, type:
omconfig storage pdisk action=initialize
controller=1 pdisk=4
omconfig Offline Physical Disk
Use the following omconfig command syntax to offline a physical disk:
Complete Syntax
omconfig storage pdisk action=offline controller=
id pdisk=<PDISKID>
where id is the controller ID. The <PDISK> variable specifies the physical
disk.