Command Line Interface Guide

omreport storage Commands 189
omreport Connector Status
Table 7-13 describes the syntax for the omreport Connector Commands.
Table 7-13. omreport Connector Commands
Required Command
Levels (1, 2, 3)
Optional name=
value pairs
Use
omreport
storage
connector
Displays all connectors present on all controllers
on the system.
NOTE: This command works only when the
controller ID is specified.
controller=id
where id is the
controller
number. For
example:
controller=0
Displays the connectors on the specified
controller.
controller =id
connector=id
where id is the
connector
number. For
example:
connector=0
Displays the specified connector.
NOTE: When the connectors are connected to the
enclosure in redundant path mode, the Name of the
connector is displayed as Logical Connector.