Command Line Interface Guide

178 omreport storage Commands
omreport Physical Disk Status
Table 7-2 describes the syntax for the omreport Physical Disk Commands.
battery Displays a list of the omreport storage battery
parameters for displaying battery information.
globalinfo Displays a list of the omreport storage
globalinfo parameters for displaying global
storage property information.
connector Displays a list of the omreport storage
connector parameters for displaying
connector information.
cachecade Displays a list of the omreport storage
cachecade parameters for displaying
cachecade properties.
NOTE: The cachecade feature will be available
from first half of calendar year 2011.
Table 7-2. omreport Physical Disk Commands
Required Command Levels (1, 2, 3)
and name=value pair
Optional name=value pairs Use
omreport storage pdisk controller=id
where id is the
controller number. For
example: controller=0
Displays all physical disks
attached to the specified
controller.
NOTE: If a physical disk
was replaced by another
disk as part of the replace
member operation, the
state of the physical disk is
displayed as
Replacing.
vdisk=id
where id is the virtual
disk number.
For example:
vdisk=1
Displays all physical disks
included in the specified
virtual disk on the
controller.
Table 7-1. omreport storage help
(continued)
Command
Level 1
Command
Level 2
Command
Level 3
Use