Users Guide

Server Administrator Services 85
Properties
Subtab: Information
Under the Properties tab, you can view general information on the remote
access device. You can also view the attributes of the IPv4 and IPv6 addresses.
Click Reset to Defaults to reset all the attributes to their system default
values.
Configuration
Subtabs: LAN | Serial Port | Serial Over LAN |Additional Configuration
Under the Configuration tab when BMC/iDRAC is configured, you can
configure the BMC/iDRAC on a LAN, serial port for BMC/iDRAC, and
BMC/iDRAC on a serial over LAN connection.
NOTE: The Additional configuration tab is available only on systems with iDRAC.
Under the Configuration tab, when DRAC is configured, you can:
Configure network properties
NOTE: The Enable NIC, NIC Selection, and Encryption Key fields display only on
Dell PowerEdge x9xx systems.
Under the Additional Configuration tab you can either enable or disable
IPv4/IPv6 properties.
NOTE: Enabling/disabling IPv4/IPv6 is possible only in a dual stack environment
(where both the IPv4 and IPv6 stacks are loaded).
Users
Subtab: Users
Under the Users tab, you can modify the remote access user configuration.
You can add, configure, and view information about Remote Access
Controller users.
NOTE: On the Dell PowerEdge x9xx systems:
- Ten user IDs are displayed. If a DRAC card is installed, sixteen user IDs are
displayed.
- Serial Over LAN Payload column is displayed.
book.book Page 85 Monday, March 14, 2011 2:40 PM