Users Guide

102 Working with Remote Access Controller
5 Specify the following user privileges:
– Select the maximum LAN user privilege level limit.
– Select the maximum serial port user privilege granted.
– On Dell PowerEdge
x9xx systems, select Enable Serial Over LAN to
enable Serial Over LAN.
6 Specify the User group for DRAC/iDRAC user privileges.
7 Click Apply Changes to save changes.
8 Click Back to Remote Access User Window to go back to the Remote
Access Users
window.
NOTE: Six additional user entries are configurable when DRAC is installed.
This results in a total of 16 users. The same username and password rules
apply to BMC/iDRAC and RAC users. When DRAC/iDRAC6 is installed, all the
16 users entries are allocated to DRAC.
Setting Platform Event Filter Alerts
You can use the Server Administrator Instrumentation Service to configure
the most relevant BMC features, such as Platform Event Filter (PEF)
parameters and alert destinations. To do this:
1
Click the System object.
2 Click the Alert Management tab.
3 Click Platform Events .
The
Platform Events window allows you to take individual action on
specific platform events. You can select those events for which you want to
take shutdown actions and generate alerts for selected actions. You can
also send alerts to specific IP address destinations of your choice.
NOTE: You must be logged in with Administrator privileges to configure the
BMC PEF Alerts.
NOTE: The Enable Platform Event Filters Alerts setting disables or enables
PEF alert generation. It is independent of the individual platform event alert
settings.
NOTE: System Power Probe Warning and System Power Probe Failure are
not supported on Dell systems without PMBus support although Server
Administrator allows you to configure them.
book.book Page 102 Monday, March 14, 2011 2:40 PM