Users Guide

122 Dell OpenManage on VMware ESXi
3 For the changes to take effect without restarting the system, use the
Restart Management Agents option in the Direct Console User Interface
(DCUI) on the local console of the VMware ESXi system.
If the changes are not effective and you cannot connect to the VMware
ESXi host using Server Administrator, restart the VMware ESXi host
system.
Uninstalling the existing OpenManage VIB
The following command can be used to uninstall the existing OpenManage
VIB:
vihostupdate.pl --server <IP Address> -r -B
Dell_OpenManage_ESXi_OM640
Reboot the system after uninstalling.
Configuring the SNMP Agent on Systems Running
VMware ESXi 4/ESXi 4.1
Server Administrator generates SNMP traps in response to changes in the
status of sensors and other monitored parameters.You must configure one or
more trap destinations on the system running Server Administrator to send
SNMP traps to a management station.
Server Administrator supports SNMP traps on VMware ESXi but does not
support SNMP Get and Set operations because VMware ESXi does not
provide the required SNMP support. You can use the VMware vSphere CLI to
configure a system running VMware ESXi to send SNMP traps to a
management application such as IT Assistant.
NOTE: For more information about using the VMware vSphere CLI, see the
VMware support site at www.vmware.com/support.
Configuring Your System to Send Traps to a Management Station Using
the vSphere CLI
1 Install the VMware vSphere CLI.
2 Open a command prompt on the system in which the vSphere CLI is
installed.