Users Guide

Working with Remote Access Controller 99
4 Configure the IPv4 and IPv6 properties as Enabled or Disabled .
5 Click Apply Changes.
Configuring Remote Access Device Users
Remote access device users can be configured using the Remote Access page.
To access this page:
1
Click the Modular Enclosure  System/Server Module  Main System
Chassis/Main System
 Remote Access object.
2 Click the Users tab.
The
Remote Access Users window displays information about users that
can be configured as BMC/iDRAC users.
3 Click User ID to configure a new or existing BMC/iDRAC user.
The
Remote Access User Configuration window allows you to configure a
specific BMC/iDRAC user.
4 Specify the following general information:
– Select
Enable User to enable the user.
– Enter the name for the user in the
User Name field.
– Select the
Change Password check box.
– Enter a new password in the
New Password field.
– Re-enter the new password in the
Confirm New Password field.
5 Specify the following user privileges:
– Select the maximum LAN user privilege level limit.
– Select the maximum serial port user privilege granted.
– On Dell PowerEdge
x9xx systems, select Enable Serial Over LAN to
enable Serial Over LAN.
6 Specify the User group for DRAC/iDRAC user privileges.
7 Click Apply Changes to save changes.
book.book Page 99 Monday, November 29, 2010 4:40 PM