Owner's Manual

214 omconfig storage Commands
Complete Syntax
omconfig storage vdisk action=replacememberdisk
controller=id vdisk=id source=<PDISKID>
destination=<PDISKID>
where id is the controller ID and virtual disk ID. The <PDISK> variable
specifies the physical disk.
To obtain the values for the controller, virtual disk, and physical disk, type
omreport storage controller to display the controller IDs and then type
omreport storage vdisk controller=ID and omreport storage pdisk
controller=ID to display the IDs for the virtual disks and physical disks
attached to the controller.
Example Syntax
In this example, you are replacing physical disk 3 on connector 0 of controller 1
of virtual disk 4 with physical disk 5. On a Serial Attached SCSI (SAS)
controller, the physical disk resides in enclosure 2.
Example for SCSI, SATA, and ATA Controllers
To replace the member disk described in this example, type:
omconfig storage vdisk action=replacememberdisk
controller=1 vdisk=4 source=0:3 destination=0:5
Example for SAS Controllers
To replace the member disk described in this example, type:
omconfig storage vdisk action=replacememberdisk
controller=1 vdisk=4 source=0:2:3 destination=
0:2:5