Owner's Manual

202 omconfig storage Commands
omconfig Check Consistency
Use the following omconfig command syntax to initiate a check consistency
on a virtual disk. The check consistency task verifies the virtual disk’s
redundant data.
Complete Syntax
omconfig storage vdisk action=checkconsistency
controller=id vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport
command. To obtain these values, type omreport storage controller to display
the controller IDs and then type omreport storage vdisk controller=ID to
display the IDs for the virtual disks attached to the controller.
Example Syntax
To run a check consistency on virtual disk 4 on controller 1, type:
omconfig storage vdisk action=checkconsistency
controller=1 vdisk=4
action=replacememberdisk controller=id vdisk=id source=
<PDISKID> destination=<PDISKID>
action=rename controller=id vdisk=id
Table 8-3. omconfig Manage Virtual Disk Commands
(continued)
Required
Command
Levels (1, 2, 3)
Optional name=value pairs