Owner's Manual

16 Introduction
Configuration features allow Server Administrator to perform essential tasks
described in detail in the following sections. This CLI guide documents all
the commands that apply to Server Administrator and Storage Management.
NOTE: You can use the CLI instead of the Server Administrator home page, and turn
the Server Administrator Web server off if you have encryption concerns. The CLI
does not use the Web server. Use the omconfig system webserver action=stop
command to turn off the Web server. The Web server starts automatically after a
reboot, so this command must be issued each time a system starts up. See "omconfig
system webserver/omconfig servermodule webserver" on page 146 for more
information.
NOTE: After installing the Dell OpenManage Server Administrator, ensure that you
log out and log in to reset the path to access Dell OpenManage CLI utilities.
NOTE: For information on terms used in this document, see the Glossary on the Dell
support website.
What's New in Version 6.4
OpenManage Server Administrator 6.4 supports:
• Express Service Code, a mathematical conversion of the System Service
Tag to a numeric format allowing easy entry to automated call-routing
system of Dell
• Additional storage controller command — cachecade
• All platforms released after OpenManage Server Administrator version 6.3
• Greater than 2 TB Serial-Attached SCSI (SAS) and Serial Advanced
Technology Attachment (SATA) drives
NOTE: For the supported operating systems list, see the Dell Systems Software
Support Matrix. To access this document, go to support.dell.com/manuals, click
Software, and select your product.
NOTE: CLI commands are not supported on systems with VMware ESXi operating
system.