User's Manual

90 omconfig: Managing Components Using the Instrumentation Service
attribute=bezel setting=enabled |
disabled
enabled: Enables the bezel removal
intrusion check during system boot.
disabled: Disables the bezel removal
intrusion check during system boot.
attribute=
bootsequence
setting=diskettefirst |
hdonly | devicelist
|cdromfirst |
opticaldrive
Instructs the BIOS which device is used
to boot the system, and the order in
which the boot routine is to check each
device.
NOTE: On Linux systems, user/user
groups upgraded to
administrator/administrator groups
cannot configure this BIOS setup setting.
attribute=
bootmode
setting=uefi | bios uefi: Enables the system to boot to
operating systems that support Unified
Extensible Firmware Interface (UEFI).
bios: Enables the system to boot to
operating systems that do not support
UEFI.
attribute=
bootorder
sequence=aliasname1,
aliasname2,.....
aliasnameN
Configures the boot sequence according
to the set aliasnames. To view the set
alias names, run the command
omreport chassis
biossetup attribute=
bootorder
.
NOTE: On Linux systems, user/user
groups upgraded to
administrator/administrator groups
cannot configure this BIOS setup setting.
Table 4-3. BIOS Setup Settings
(continued)
name=value pair 1
attribute=
name=value pair 2
setting=
Description