Read me

file:///T|/htdocs/SOFTWARE/svradmin/6.3/en/README/readme.txt[10/26/2012 8:28:05 AM]
The amount of time varies depending on the hardware system and
operating system.
[188345]
=====================================================================
NOTES FOR THE INSTRUMENTATION SERVICE
=====================================================================
* When configuring BIOS setup options through server administrator,
if conflict BIOS settings exist, the update attempt may fail at
system reboot and possibly none of the BIOS setup option is updated.
For example, when you configure Embedded SATA Controller to RAID
and Boot Mode to UEFI simultaneously (UEFI does not support RAID
option), this conflict prevents any BIOS configuration to be
updated (at system reboot).
* On certain systems, user-defined thresholds set under Server
Administrator become the default thresholds after uninstalling
Server Administrator.
After you change the threshold value of a probe on certain systems
running Server Administrator and then uninstall Server Administrator,
the changed threshold value becomes the default threshold value.
* When modifying the warning threshold settings, the values are stored
in the firmware as discrete integer values and scaled for display.
If the modified value is not a discrete integer, it may change when
saved.
* Fan redundancy can have the following states:
Fully Redundant: The sensors display this status if all the fans
in the system are present and are in a non-failure state.
OR
Redundancy Lost: The sensors display this status whenever any
system fan fails or is removed from the chassis.
* If a system with memory redundancy enabled enters a "redundancy
lost" state, it may not be apparent which memory module is the
cause. If you cannot determine which DIMM to replace, see the
"switch to spare memory detected" log entry in the ESM system
log to find the memory module that failed.
* If you run Server Administrator while the system is in "OS Install
Mode", memory may be reported incorrectly by Server Administrator.
To avoid this issue, you must disable "OS Install Mode" before
running Server Administrator.
* If you have to uninstall and reinstall the operating system SNMP