Read me

file:///T|/htdocs/SOFTWARE/svradmin/6.3/en/README/readme.txt[10/26/2012 8:28:05 AM]

"racadm sslcertupload"

"racadm sslcsrgen"

"racadm fwupdate"

* If the RAC configuration is reset to factory defaults using the

"racadm racresetcfg" command, the RAC configuration tab in Server

Administrator does not reflect the reset configuration settings

until the system reboots. Also, the RAC configuration page in

Server Administrator cannot be used to make any configuration

changes until the system reboots.

* The RAC does not support local RAC user IDs with special

characters. When adding a local RAC user, use only alphanumeric

characters for the user name.

* While the RAC is being reset, the Instrumentation Service cannot

read sensor data for certain systems. As a result, the voltage,

temperature, and other probes may not be visible on the Server

Administrator home page until the RAC has completed resetting.

* The RAC may not send traps when your system is locked up. To enable

traps to be sent when the system is locked, configure the watchdog

timer using the Server Administrator GUI. In the Server

Administrator GUI, click the "Properties" tab and ensure that the

"Auto Recovery" is selected. The default value of the "Action On

Hung Operating System Detection" setting is "None". "None"

indicates that detection will not be performed.

* RAC firmware 2.0 and higher does not support passwords with special

characters (non-alphanumeric) only for RAC user IDs logging in

using the Web-based interface (with Local RAC Authentication). If

you created RAC user IDs using previous versions of the firmware or

if you created user IDs using Server Administrator that is running

version 2.0 firmware on the managed system, you cannot log in to

the RAC.

Use one of these methods to correct this issue:

- Change your passwords before updating the firmware.

- Use the following CLI command to change the password:

"omconfig rac users username=xx userpassword=yy"

where "xx" is the original user ID and "yy" is the new password.

- Change the password through Server Administrator using the "User"

tab. Ensure that the check box to change the password is checked.

Enter a new password, and then enter it again to validate the

change.