Users Guide


Does my controller support this feature? See "Supported Features."
Use the Enable Alarm task to enable the controller's alarm. When enabled, the alarm sounds in the event of a device failure.

Disable Alarm (Controller)

Does my controller support this feature? See "Supported Features."
Use the Disable Alarm task to disable the controller's alarm. When disabled, the alarm does not sound in the event of a device failure.

Quiet Alarm (Controller)

Does my controller support this feature? See "Supported Features."
Use the Quiet Alarm task to quiet the controller's alarm when it is sounding. After it is quieted, the alarm is still enabled in the event of a future device failure.

Test Alarm (Controller)

Does my controller support this feature? See "Supported Features."
Use the Test Alarm task to test whether the controller alarm is functional. The alarm will sound for about two seconds.

Set Rebuild Rate

Does my controller support this feature? See "Supported Features."
Use the Set Rebuild Rate task to change the rebuild rate. See "Set Rebuild Rate" for more information.

Export Log File

Does my controller support this feature? See "Supported Features."
Use this task to export the controller log to a text file. See "Export Log" for more information.

Controller Components
For information on attached components, see the following topics:
l "Battery Properties and Tasks"
l "Connector Properties and Tasks"
l "Enclosure and Backplane Properties and Tasks"
l "Firmware/Driver Properties"
l "Virtual Disk Properties and Tasks"

Foreign Configuration Operations

Does my controller support this feature? See "Supported Features."
NOTE: The Test Alarm task is only available on the CERC SATA1.5/6ch controller.