Users Guide


Clearing the Redundant Path View
If you do not want the redundant path view, physically disconnect the connector port from the enclosure and reboot the system. After the system reboots, the
user interface will still display the Logical Connector, but in a critical state. If you are certain you do not want the redundant path mode, select Clear
Redundant Path view from the Connector Tasks.
Selecting this option clears the redundant path view and the connectors are represented on the user interface as Connector 0 and Connector 1.

Related Tasks
l "Redundant Path Configuration"

Logical Connector Components
For information on attached components, see the following topic:
l "Enclosure and Backplane Properties and Tasks"
Back to Contents Page
