Users Guide

94 Working with Remote Access Controller
6 Configure the following IPv4 Properties:
• IP Address Source
•IP Address
•Subnet Mask
• Gateway Address
7 Configure the following IPv6 Properties:
• IP Address Source
•IP Address
•Prefix Length
•Default Gateway
• DNS Address Source
• Preferred DNS Server
• Alternate DNS Server
NOTE: You will be able to configure the IPv4 and IPv6 address details only if
you enable the IPv4 and IPv6 properties under Additional Configuration.
8 Click Apply Changes.
Configuring the Remote Access Device to use a
Serial Port Connection
You can configure the BMC for communication over a serial port connection.
To do this:
1
Click the Modular Enclosure → System/Server Module → Main System
Chassis/Main System
→ Remote Access object.
2 Click the Configuration tab.
3 Click Serial Port .
The
Serial Port Configuration window appears.
4 Configure the following details:
• Connection Mode Setting
•Baud Rate
•Flow Control
• Channel Privilege Level Limit
book.book Page 94 Friday, December 4, 2009 3:20 PM