User's Manual


Does my enclosure support this feature? See "Supported Features."
Use the Blink task to blink the light-emitting diodes (LEDs) on the enclosure. You may want to use this task to locate an enclosure. The LEDs on the enclosure
may display different colors and blinking patterns. Refer to the enclosure hardware documentation for more information on what the blink colors and patterns
indicate.

Set Temperature Probe Value

Does my enclosure support this feature? See "Supported Features."
Use the Set Temperature Probe Values task to specify the Warning and Failure thresholds for the enclosure's temperature probes. See "Set Temperature
Probe Values" for more information.

Identifying an Open Connector for the Enclosure

Does my controller support this feature? See "Supported Features."
If you have not yet attached the enclosure to an open connector, you may need to identify a connector on the controller that can be used for this purpose. To
identify an open connector:

1. Expand the Storage Management tree view until the controller object is expanded. When the controller object is expanded, the tree view displays the
controller's connectors. These connectors are numbered starting from zero.

2. Identify a connector that is not attached to storage. If the connector is already attached to storage, then the Connector object can be expanded to
display an enclosure or backplane and the attached physical disks. A Connector object that cannot be expanded in the tree view is an open connector
not currently attached to storage. Storage Management displays a number for each connector. These numbers correspond to the connector numbers on
the controller hardware. You can use these numbers to identify which open connector displayed in the tree view is the open connector on the controller
hardware.

Checking the Enclosure's Temperature

Does my controller support this feature? See "Supported Features."
To check the enclosure's temperature:

1. Expand the tree view until the Temperatures object is displayed.

2. Select the Temperatures object. The temperature reported by the temperature probe is displayed in Celsius in the Reading column in the right pane.
For information related to the enclosure's temperature, see the following:
l "Enclosure Temperature Probes"
l "Set Temperature Probe Values"
l "Temperature Probe Properties and Tasks"
l "SMART Thermal Shutdown" (does not apply to the Ultra SCSI, Ultra2 SCSI, Ultra160 SCSI, LSI 1020, LSI 1030, and LSI PCI-e U320 controllers)

Verifying the Enclosure's EMM Firmware Version

Does my controller support this feature? See "Supported Features."
The firmware for the Enclosure Management Modules (EMMs) must be at the same level. The status of the EMMs is displayed as degraded if there is a
mismatch between the EMM firmware.
To verify the EMM firmware version:

1. Expand the tree view until the EMMs object is displayed.

2. Select the EMMs object. The firmware version for each EMM is displayed in the Firmware Version column in the right pane.